Kenmore refrigerator repair
Kenmore Refrigerator Repair in Springfield, VA
Your Kenmore refrigerator is diagnosed in place at your Springfield address. You learn which part failed and what the fix costs before anything is repaired.
Booking online? Include the kenmore refrigerator model number and your Springfield address so parts can be checked ahead of the visit.
Step one covers the appliance; step two, your contact details. We follow up to book the visit.
Kenmore Refrigerator Repair for Owners, Renters and Landlords
This page covers ZIP 22150. Kenmore has no connection to us, and an appliance still inside the Kenmore warranty period belongs with the manufacturer first. After that, send us the model number with your booking so parts can be checked ahead of the visit.
How a Refrigerator Repair Visit Works
Tell Us What's Wrong
Name the make, add the model number if it is handy, and describe the symptom. A picture of the label inside the door lets us check parts.
Diagnosis at Your Home
The technician tests the appliance along with its power, water, drain, gas or vent connections until the fault is confirmed.
A Price Before Work
We name the failed part and give you the cost of fixing it. Work starts only after you agree.
Repair and Check
The part is installed and the appliance is run through a cycle so you can watch it working.
Related Repairs
Other appliances, brands and service areas on the site.
Kenmore Refrigerator Symptoms
One symptom can have several causes, so the technician tests the likely parts on site and quotes only once the culprit is confirmed.
- Not Cooling
- Ice Maker Not Working
- Water Dispenser Issue
- Making Strange Noise
- Door Seal Damaged
- Freezer Not Freezing
- Leaking Water
- Temperature Fluctuating
- Compressor Failure
- Start Relay Failure
- Condenser Coils Dirty
- Condenser Fan Failure
- Evaporator Fan Failure
- Refrigerant Leak
- Not Defrosting
- Defrost Heater Failure
- Defrost Thermostat Failure
- Defrost Timer Failure
- Frost on Evaporator Coils
- Ice Buildup on Back Wall
- Defrost Drain Clogged
- Drain Pan Overflowing
- Water Pooling Inside Refrigerator
- Water Under Crisper Drawer
- Food Freezing in Fresh Food Section
- Refrigerator Running Too Cold
- Freezer Running Too Cold
- Not Staying Cold
- Runs Constantly / Never Cycles Off
- Short Cycling
- Control Board Failure
- Thermostat Failure
- Temperature Sensor / Thermistor Failure
- Error Codes Displayed
- Clicking Noise
- Loud Buzzing Noise
- Humming Loudly
- Rattling Noise
- Knocking Noise
- Water Dispenser Slow Flow
- Water Dispenser Not Working
- Water Tastes Bad or Has Odor
- Water Filter Not Working
- No Water After Filter Replacement
- Ice Dispenser Jammed
- Ice Maker Overflowing
- Ice Maker Leaking
- Ice Tastes Bad or Has Odor
- Ice Clumping Together
- Ice Production Too Slow
- Fill Tube Frozen
- Water Line Frozen
- Crushed Ice Not Working
- Cubed Ice Not Working
- Ice Not Ejecting from Mold
- Refrigerator Door Not Closing Properly
- Door Hinge Broken
- Door Handle Broken or Loose
- Door Alarm Beeping
- Beeping Constantly
- Interior Light Not Working
- Display Panel Not Working
- Refrigerator Won't Turn On
- Tripping Circuit Breaker
- Exterior Sweating / Condensation
- French Door Not Sealing Properly
- Bottom Drawer Not Cooling
- Produce Freezing in Crisper
- Milk or Beverages Freezing
- Refrigerator Gradually Warming Up
- Compressor Overheating and Shutting Off
- Ice Maker Shutoff Arm Stuck
- Pink Slime or Mold in Ice Maker
- Mineral / Scale Buildup in Ice Maker
- Door Bin / Shelf Broken
Kenmore Appliances We Service
Kenmore Refrigerator Notes
Kenmore refrigerator repair across the Springfield ZIP code we cover. We find the fault at your home and give you a price to approve before anything is done.
Springfield sits beside the Mixing Bowl, and it's close enough to Fort Belvoir and the NGA campus that many households here are on military or federal assignments. Those families move on a schedule, and that shapes appliance calls as much as the houses do: a washer that has to be working before a move-out walk-through, a refrigerator in a house between tenants, machines that came with a rental and belong to someone out of state.
On a Kenmore refrigerator, the checks run in this order: airflow before anything else (the condenser coil and fan, the evaporator fan, and whether frost has sealed the vents between the two compartments), then the defrost heater, its sensor and the control, and the compressor and refrigerant last, since a frosted-over coil and a failing compressor both give you a warm cabinet at very different costs. Worth knowing as well: Kenmore began as a Sears label and never had factories of its own; the three digits before the dot in the model number name the maker, such as 106 for Whirlpool, 253 for Frigidaire and 795 for LG.
Call or book online, and we'll agree on a time together.
How a Kenmore refrigerator is put together
Diagnosing a Kenmore refrigerator begins at the model label, because a 106 is a Whirlpool design, a 253 is Frigidaire and a 795 is LG, and each has its own defrost system, board layout and ice maker. The complaint that brings most of them in is the same, though: the fresh-food side is too warm while the freezer seems fine. On older Whirlpool and Frigidaire units, that is usually a frosted evaporator from a failed defrost heater, thermostat or timer, or a stopped evaporator fan. LG-built models add a linear compressor and a more electronic defrost, so we read the board's diagnostics too. A top-freezer that clicks and won't start often needs a start relay. Garage refrigerators work hard in a Virginia summer, and a dusty condenser makes it worse.
Also: two Kenmores that look alike on the outside may share nothing inside, so no part can be picked from the badge alone.
Where Kenmore refrigerators tend to fail
The first things we check on this model line: Warm fresh-food side from a frosted coil; Evaporator fan quit; Compressor start relay clicking; Ice maker or fill valve failure; Linear compressor fault on LG-built models.
Those are starting points, not a verdict. One symptom can trace to a cheap part or an expensive one, so the cause is confirmed at your home before you're quoted.
Where the refrigerator sits in Springfield
Many Springfield households keep a second refrigerator in the basement or garage for bulk shopping. That one tends to be older and dustier than the kitchen unit, and it's the one that fails in August.
A refrigerator left running in an empty house between tenants in Springfield can fail unnoticed; a quick check before handing back the keys is worth it.
The refrigerator symptom that fools people
Whatever the brand, the refrigerator complaint most often misread is a fresh-food side that is only cool while the freezer stays solid, which usually means a stopped fan or a defrost fault choking the airflow rather than a refrigerator at the end of its life.
The local factor to keep in mind in Springfield, where most homes are postwar houses and townhouses: refrigerators in hot summer garages, units boxed tightly into condo cabinetry with little room to shed heat, and door gaskets that sweat and frost through humid months.
Gas ranges, dryers and safety
Glowing oven igniters with no flame, clicking burners that never light and gas dryers that spin without heat are everyday gas repairs. The usual parts are a weak igniter, a valve coil or a flame sensor.
The piping and the shutoff valve upstream of the appliance belong to a gas fitter; if we spot trouble there, you'll hear about it.
In Brief
Kenmore Refrigerator Questions
Brief answers to what customers most often ask us. Don't see yours? Ask when you call, or add it to the notes when you book online.
Still have a question?
Get in touch with the brand, the symptom and, if you can find it, the model number. Some things we can answer right away; others need a technician in front of the machine.
48 of them, from everyday names such as Whirlpool, GE Appliances, Samsung, LG, Frigidaire and Maytag to built-in and European makers like Sub-Zero, Wolf, Thermador, Bosch and Miele, and commercial equipment from True, Hoshizaki, Manitowoc and others. The brands page has the full list.
Yes, that's common in Springfield. A tenant opens the door, the owner or manager says yes or no to the price by phone or email, and each of you gets the same written note of the fault and the fix. Buildings that want contractor paperwork should have their requirements sent to us at booking.
We can't say until we know what failed. A valve, switch, pump or element costs far less than a control board or sealed-system work, and you get the actual figure after diagnosis, before any repair.
It's more likely if you send the model number when you book. The Kenmore name has been on machines from more than one manufacturer, so parts are ordered by the model number, never by the badge. If a part has to be ordered, you hear the lead time before you decide.