Frigidaire washer repair
Frigidaire Washer Repair in Vienna, Tysons & Oakton, VA
Your Frigidaire washer is diagnosed in place at your Vienna, Tysons & Oakton address. You learn which part failed and what the fix costs before anything is repaired.
Booking online? Include the frigidaire washer model number and your Vienna, Tysons & Oakton address so parts can be checked ahead of the visit.
Step one covers the appliance; step two, your contact details. We follow up to book the visit.
washer brands we service
Frigidaire Washer Repair for Owners, Renters and Landlords
This page covers ZIPs 22181 and 22182 and 22124. Frigidaire has no connection to us, and an appliance still inside the Frigidaire warranty period belongs with the manufacturer first. After that, send us the model number with your booking so parts can be checked ahead of the visit.
How a Washer Repair Visit Works
Tell Us What's Wrong
Name the make, add the model number if it is handy, and describe the symptom. A picture of the label inside the door lets us check parts.
Diagnosis at Your Home
The technician tests the appliance along with its power, water, drain, gas or vent connections until the fault is confirmed.
A Price Before Work
We name the failed part and give you the cost of fixing it. Work starts only after you agree.
Repair and Check
The part is installed and the appliance is run through a cycle so you can watch it working.
Related Repairs
Other appliances, brands and service areas on the site.
Frigidaire Washer Symptoms
One symptom can have several causes, so the technician tests the likely parts on site and quotes only once the culprit is confirmed.
- Not Spinning
- Not Draining
- Making Loud Noise
- Won't Start
- Leaking Water
- Not Filling with Water
- Door Won't Lock
- Vibrating Excessively
- Error Codes Displayed
- Not Agitating
- Clothes Not Getting Clean
- Washer Smells Bad
- Mold in Drum or Gasket
- Musty Odor Transferring to Clothes
- Door Gasket Mold
- Not Rinsing Properly
- Too Much Suds / Oversudsing
- Detergent Not Dispensing
- Fabric Softener Not Dispensing
- Bleach Dispenser Clogged
- Spin Cycle Stopping Early
- Not Completing Full Cycle
- Cycle Taking Too Long
- Pausing Mid-Cycle
- Filling Too Slowly
- Overfilling with Water
- Standing Water After Cycle
- Not Draining Completely
- Grinding Noise During Wash
- Banging Noise During Spin
- Squealing Noise
- Clicking Noise During Cycle
- Burning Smell from Washer
- Door Won't Open After Cycle
- Door Glass Cracked or Broken
- Door Seal / Gasket Torn or Damaged
- Leaking from Bottom
- Leaking from Door
- Leaking from Back of Washer
- Leaking from Detergent Drawer
- Drum Not Turning
- Agitator Not Working
- Agitator Dogs / Cogs Worn Out
- Drum Bearing Making Noise
- Drive Belt Broken
- Motor Failure
- Drain Pump Failure
- Water Inlet Valve Failure
- Lid Switch / Lock Failure
- Control Board Failure
- Water Temperature Wrong
- Washing Cold Only / No Hot Water
- Clothes Getting Damaged in Washer
- Tearing or Ripping Clothes
- Clothes Coming Out Tangled
- Soap Residue on Clothes
- Fabric Softener Spots on Clothes
- Rust Stains on Clothes
- Washer Won't Turn On
- Display / Control Panel Not Working
- Buttons Not Responding
- Pausing Randomly During Cycle
- Tripping Circuit Breaker
- Shaking the Floor During Spin
- Washer Moving Across Floor During Spin
- Not Balancing Load During Spin
- UE / Unbalance Error (LG)
- OE / Drain Error (LG)
- LE / Motor Error (LG)
- DE / Door Error (LG)
- 5E / SE Drain Error (Samsung)
- F21 Drain Error (Whirlpool)
- F5 / dL Lid Lock Error (Whirlpool / GE)
- Drum Bearing Replacement Needed
- Shock Absorbers Worn Out
- Spider Arm / Drum Support Broken
- Pump Filter Clogged
Other Washer Brands
Frigidaire Appliances We Service
Frigidaire Washer Notes
Frigidaire washer repair across all 3 Vienna, Tysons & Oakton ZIP codes we cover. We find the fault at your home and give you a price to approve before anything is done.
This stretch of Fairfax County runs from the incorporated Town of Vienna north to the wooded roads around Wolf Trap and west along Hunter Mill Road into Oakton. Its slice of Tysons, clustered around the Spring Hill station on Route 7, adds new apartment and condominium towers to an area otherwise made of detached houses and townhouses.
On a Frigidaire washer, the checks run in this order: the way water leaves the tub, then the way it enters, then the drive system, since a washer stuck full of water or refusing to spin is usually blocked at the pump rather than burned out at the motor. Worth knowing as well: Frigidaire was a General Motors division until 1979 and has been an Electrolux brand since 1986, sharing a great deal of hardware with Electrolux-badged models.
Call or book online, and we'll agree on a time together.
How a Frigidaire washer is put together
Frigidaire washers include top-loaders, front-loaders and stacked laundry centers, and the common failures differ. Top-loaders often stop spinning because of a failed lid switch or lid lock, and worn suspension springs cause loud banging during spin. Laundry centers pack the washer into a tight frame beneath the dryer, so the drain pump, belt and transmission are harder to reach but still serviceable. Front-loaders fail on door locks, drain pumps and door boots, and bearings get loud over time. In a rental unit, overloaded machines and small socks in the pump are common causes. We check the switch, pump and suspension before looking at the control or transmission.
Also: on a frost-free Frigidaire upright freezer, a cabinet that warms up is more often a defrost heater, sensor or fan than a failed compressor.
Where Frigidaire washers tend to fail
The first things we check on this model line: Lid switch not closing the circuit; Suspension springs stretched; Laundry center belt slipping; Front-load door lock failed; Drain pump blocked by small items.
Those are starting points, not a verdict. One symptom can trace to a cheap part or an expensive one, so the cause is confirmed at your home before you're quoted.
Where the washer sits in Vienna, Tysons & Oakton
Behind a washer in Vienna, Tysons & Oakton you may find old galvanized pipe or brand-new PEX, and a fair share of faults turn out to be in that plumbing rather than the machine.
Water in Vienna, Tysons & Oakton comes from more than one utility, but in each case minerals settle where water dries, in inlet screens, fill valves and spray arms.
The washer symptom that fools people
Whatever the brand, the washer complaint most often misread is an error code taken as proof that an expensive part has died, when the washer is only reporting a condition such as an unbalanced load, a supply valve left half closed, or a drain hose pushed so deep into its standpipe that it siphons.
The local factor to keep in mind in Vienna, Tysons & Oakton, where most homes are postwar houses: washers on upper floors of townhouses, where a leak reaches the ceiling below, stacked pairs in tight condo closets, and front-loader door seals that grow mildew in a humid summer.
Why the model number matters
Second trips in Vienna, Tysons & Oakton almost always come down to a missing part. With the model number in hand we can look up that model's known weak spots and load the likely parts before leaving.
The label hides inside a door or lid, on the frame, behind the toe kick or on the back panel. Photograph it and attach the picture to your booking.
In Brief
Frigidaire Washer Questions
Brief answers to what customers most often ask us. Don't see yours? Ask when you call, or add it to the notes when you book online.
Still have a question?
Get in touch with the brand, the symptom and, if you can find it, the model number. Some things we can answer right away; others need a technician in front of the machine.
Yes, and plainly. When a fix would eat much of the price of a comparable new model and the unit is late in its life, we'll suggest you replace it rather than repair it, in Vienna, Tysons & Oakton or anywhere. Built-ins get more latitude, since a new one usually means new cabinetry too.
We do. Restaurants, cafés and offices in Vienna, Tysons & Oakton call us for reach-ins, undercounter units, ice machines, and commercial ovens and ranges as well as home appliances, and we plan the visit around your service.
We can't say until we know what failed. A valve, switch, pump or element costs far less than a control board or sealed-system work, and you get the actual figure after diagnosis, before any repair.
It's more likely if you send the model number when you book. Frigidaire is built on the Electrolux platform, and parts shared across that family are often still easy to find after a model is discontinued. If a part has to be ordered, you hear the lead time before you decide.