Perlick Appliance Repair in Springfield, VA

Perlick engineers and builds its own appliances, so its parts and repair procedures are specific to Perlick, and parts for jobs in Springfield come through Perlick's own supply chain.

Include the model number when you book. The label is usually inside the door or lid, on the frame, behind the lower kick panel or on the back. That number lets us check the weak points of that particular platform and load those parts before the visit, instead of ordering after it.

Down commercial equipment costs money every hour it sits. For Perlick calls in Springfield we try to arrive outside your rush, and when you book we'll want the model and serial numbers so the parts that usually fail come with us.

Cold holding and ice carry food-safety duties, so we leave a written record of the fault and the parts replaced. When the failure comes from upkeep (a condenser matted with grease, a split gasket, an ice machine overdue for descaling) we'll say so, because that is what causes the next breakdown.

Basement washers and dryers in ramblers and split-levels, including dryers whose exhaust crosses the whole basement to reach an outside wall; second refrigerators and freezers working through summer in the garage; townhouse washers leaking from a bedroom-level closet; and rental appliances that need to be right before new tenants move in.

Whatever the badge says, a Perlick appliance depends on the drain, vent, circuit and supply line it's connected to. In Springfield the washer and dryer usually sit in the basement in most of the ramblers and split-levels, and a closet on the bedroom level in the townhouses, and in postwar houses and townhouses those connections are often where a fault begins.

Humidity works on refrigerators too. When a door gasket stops sealing, damp summer air pours in, frost builds on the evaporator and the cabinet sweats along the door edge.

Close a dollar bill in the door at several points and pull it out; if it slides free with no drag, the gasket isn't sealing there. A worn gasket is an inexpensive repair that saves the compressor a lot of work.

In townhouses and many newer houses around Springfield, the washer is on the bedroom floor, so a leak doesn't stay on the floor; it comes through the ceiling below. Most leaks start at a hookup rather than inside the machine: a rubber supply hose that finally split, a drain hose that slipped out of its standpipe, a door boot torn by a zipper.

Stainless-braided hoses, a pan under the machine and a valve within arm's reach cost little next to a ceiling repair. When water shows up, close the valve and pull the plug first, then call.